QB60 Electric Water Pump

When low water pressure gets you down, power it up with our QB60 Peripheral Water Pump.Pumping out at a rate of 35L/min with a delivery head of 32m. lt is the perfect solution where constant on-demand water pressure is needed at the open and close of any tap.Use it to pump your pool,increase water pressure in your pipes, water your gardens, irrigate, clean and more.This pump is simple to install and easy to use.There is no need of any sophisticated knowledge of pumping.

The qb water pumps must be instlled in a dry well-ventlated place with an ambient temperature of no more than 40C.when the pump in place on a solid fat surface using suitable bots to avoid vibration. The pump must be in a horizontal position to ensure that the bearings operate correctly.The diameter of the intake pipe must be no than that of the take mouth if the intake height exceeds 4 meters, use a pipe with a larger diameter.The diameter of the delivery pipe mustbe chosen to suit the flow rate and pressure required at the take off points. The intake pipe must be slighty angled up towards the intake mouth to avoid theformation ofair lock . Make sure that the intake pipe is completely airtight and immersed in the water by at least alf a meter to avoid the formation of vortex.
 

Application

· They are recommended for pumping clean water without abrasive particles and liquids that are non-corrosive

· For domestic use and sprinkling irrigation for garden as well as supplying water to hotel, villa and high building

· Must be installed in enclosed place or keep it away from inclement weather

 

Performance

· High heads with respect to power requirements

· Stable operating curves, with small variations in delivery rater with respect to large variations in the pressure demand

· High tolerance of the presence of entrained air in the liquid being pumped

 

Operating limits

· Max. suction:9m

· Max. medium temperature+40℃

· Max. ambient temperature+40℃

· Max. pressure: 6 bar

· Transport medium:PH6.5-8.5

 

Motor information

· Two-pole induction motor

· Single phase/three phase

· Thermal protector for single phase

· Insulation class:B

· Protection class:IP44

 

Material

· 100% copper wire

· Pump body: Cast iron

· Motor housing: Aluminum

· Impeller: Brass

· Mechanical seal: Ceramic&Graphite

· Shaft:45#steel/ stainless steel